BRAKE ACTUATOR (for Hatchback) > INSTALLATION |
| 1. INSTALL BRAKE ACTUATOR BOLT CUSHION |
Install the 3 brake actuator bolt cushions to the brake actuator bracket assembly.
Install the 3 brake actuator case collars to the brake actuator bolt cushion.
| 2. INSTALL BRAKE ACTUATOR BRACKET ASSEMBLY |
![]() |
Install the actuator bracket with the 3 bolts in the sequence shown in the illustration.
| 3. INSTALL BRAKE ACTUATOR ASSEMBLY (w/o VSC) |
![]() |
Install the brake actuator with bracket with the 3 bolts in the sequence shown in the illustration.
Using a union nut wrench 10 mm, connect the 6 brake tubes to the brake actuator assembly.
![]() |
Connect the brake actuator connector.
| *1 | Lock lever |
| 4. INSTALL BRAKE ACTUATOR ASSEMBLY (w/ VSC) |
![]() |
Install the brake actuator with bracket with the 3 bolts in the sequence shown in the illustration.
Using a union nut wrench 10 mm and union nut wrench 12 mm, connect the 6 brake tubes to the brake actuator assembly.
![]() |
Connect the brake actuator connector.
| *1 | Lock lever |
| 5. INSTALL BATTERY CARRIER |
Install the battery carrier with the 5 bolts.
Engage the 6 clamps and connect the wire harness to the battery carrier.
| 6. INSTALL BATTERY TRAY |
| 7. INSTALL BATTERY |
Install the battery onto the battery tray with the battery clamp.
Connect the cable to the battery terminal.
| 8. BLEED BRAKE LINE |
| 9. BLEED CLUTCH LINE (for Manual Transaxle) |
| 10. INSPECT ACTUATOR WITH TECHSTREAM |
| 11. CHECK AND CLEAR DTC |