Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › FRONT SPEED SENSOR (for Sedan)

FRONT SPEED SENSOR (for Sedan) > INSTALLATION



1. INSTALL FRONT SPEED SENSOR
  1. Install the speed sensor to the steering knuckle with the bolt.

    Torque:
    8.5 N*m{ 87 kgf*cm , 75 in.*lbf }

    NOTICE:
    1. Check that the speed sensor tip and installation portion are free of foreign matter.
    2. Install the speed sensor without turning it from its original installation angle.

  1. Install the clamp to the shock absorber with the bolt.

    Torque:
    29 N*m{ 300 kgf*cm , 22 ft.*lbf }

  1. Install the clamp to the body with the bolt.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }

  1. Install the 3 clips.

  1. Connect the speed sensor connector.

  1. Install the speed sensor clip to the body.



2. INSTALL FRONT FENDER LINER
  1. Install the front fender liner with the 3 screws, 6 clips and 4 grommets.

    NOTICE:
    The speed sensor wire should not protrude beyond the front fender liner.



3. INSTALL FRONT WHEEL

Torque:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }



4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



5. CHECK ABS SENSOR SIGNAL
(Click here)