Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › FRONT SPEED SENSOR (for Hatchback)

FRONT SPEED SENSOR (for Hatchback) > INSTALLATION



1. INSTALL FRONT SPEED SENSOR
  1. Install the speed sensor onto the steering knuckle with the bolt.

    Torque:
    8.5 N*m{ 87 kgf*cm , 75 in.*lbf }

    NOTICE:
    1. Check that the speed sensor tip and installation portion are free of foreign matter.
    2. Install the speed sensor without turning it from its original installation angle.

  1. Install the No. 1 clamp onto the shock absorber with the bolt.

    Torque:
    29 N*m{ 300 kgf*cm , 22 ft.*lbf }

  1. Install the No. 2 clamp onto the body with the bolt.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }

  1. Engage the 2 clamps onto the body.

  1. Install the No. 3 clamp onto the body.

  1. Connect the speed sensor connector.

  1. Engage the clamp onto the body.



2. INSTALL FRONT FENDER LINER
  1. Install the front fender liner with 7 clips, 2 screws and 4 new grommets.



3. INSTALL FRONT WHEEL

Torque:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }



4. CHECK ABS SENSOR SIGNAL (w/o VSC)
(Click here)


5. CHECK VSC SENSOR SIGNAL (w/ VSC)
(Click here)