Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › REAR SPEED SENSOR (for Sedan)

REAR SPEED SENSOR (for Sedan) > INSTALLATION



1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY
  1. Install the axle hub and bearing to the axle beam with the 4 bolts.

    Torque:
    90 N*m{ 918 kgf*cm , 67 ft.*lbf }



2. INSPECT REAR AXLE HUB BEARING


C121815
  1. Inspect the axle hub and bearing backlash.

    1. Using a dial indicator, check the backlash near the center of the axle hub.

      Maximum:
      0.05 mm (0.0020 in.)

      If the backlash exceeds the maximum, replace the axle hub and bearing.



    C121816
  1. Inspect the axle hub and bearing runout.

    1. Using a dial indicator, check the runout of the surface of the axle hub.

      Maximum:
      0.07 mm (0.0028 in.)

      If the runout exceeds the maximum, replace the axle hub and bearing.



3. CONNECT SKID CONTROL SENSOR WIRE


C107565
  1. Connect the skid control sensor wire connector.



4. INSTALL REAR BRAKE DRUM SUB-ASSEMBLY


5. ADJUST REAR DRUM BRAKE SHOE CLEARANCE
  1. Provisionally install the 2 hub nuts.



    F040023E07
  1. Remove the hole plug, and turn the adjuster to expand the shoe until the drum locks.
    Text in Illustration 
    *1
    Automatic Adjust Lever
    V100135
    Expand

  1. Using a screwdriver, release the adjuster 12 notches.

  1. Install the hole plug.



6. INSTALL REAR WHEEL

Torque:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }



7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



8. CHECK ABS SENSOR SIGNAL
(Click here)