Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › ECM (for Hatchback)

ECM (for Hatchback) > INSTALLATION



1. INSTALL NO. 2 ECM BRACKET
  1. Install the No. 2 ECM bracket onto the ECM with the 2 screws.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }



2. INSTALL NO. 1 ECM BRACKET
  1. Install the No. 1 ECM bracket onto the ECM with the 2 screws.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }



3. INSTALL ECM
  1. Install the ECM with the bolt and nut.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

    NOTICE:
    If a component has been dropped or subjected to a strong impact, replace it.

  1. Pull down the lever to engage the lock and connect the 2 connectors to the ECM.

    NOTICE:
    Make sure that the levers are securely locked.



4. INSTALL OUTER COWL TOP PANEL
  1. Install the outer cowl top panel with the 8 bolts.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }

  1. Engage the 2 clamps and install the wire harness.



5. INSTALL INNER COWL TOP TO COWL BRACE
  1. Install the cowl top to cowl brace with the 2 bolts.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }



6. INSTALL FRONT AIR SHUTTER SEAL RH

HINT:
Use the same procedure for the RH and LH sides.



7. INSTALL FRONT NO. 1 VENTILATOR SEAL
  1. Engage the clip and install the front No. 1 ventilator seal.



8. INSTALL FRONT WIPER MOTOR AND LINK
(Click here)


9. PERFORM INITIALIZATION
(Click here)