MASS AIR FLOW METER (for Sedan) > ON-VEHICLE INSPECTION |
| 1. INSPECT MASS AIR FLOW METER |
Perform confirmation driving pattern.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Clear the DTCs (Click here).
Start the engine and warm it up with all the accessory switches OFF (until the engine coolant temperature is 75°C (167°F) or more).
Drive the vehicle at 50 km/h (31 mph) or more for 3 to 5 minutes *1.
Allow the engine to idle for 2 minutes *2.
Perform steps *1 and *2 at least 3 times.

Read the value using the Techstream (Long FT#1).
Select the following menu items: Powertrain / Engine and ECT / Data List / Long FT #1.
Read the values displayed on the tester.
Read the value using the Techstream (MAF).
Turn the ignition switch to ACC.
Turn the ignition switch ON (do not run the engine).
Turn the tester ON.
Select the following menu items: Powertrain / Engine and ECT / Data List / MAF.
Wait 30 seconds, and read the values on the Techstream.