CAN COMMUNICATION SYSTEM (for Sedan) > ECM Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| ECM Communication Stop Mode |
|
|

| 1.CHECK CAN BUS LINE FOR DISCONNECTION (ECM MAIN WIRE) |
![]() |
Turn the ignition switch off.
Disconnect the A21 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A21-41 (CANH) - A21-49 (CANL) | Ignition switch off | 108 to 132 Ω |
| *a | Front view of wire harness connector (to ECM) |
|
| ||||
| OK | |
| 2.INSPECT ECM POWER SOURCE CIRCUIT |
Inspect the power source circuit (Click here).
|
| ||||
| OK | ||
| ||