Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM (for Sedan)

LIGHTING SYSTEM (for Sedan) > Illumination Circuit


DESCRIPTION

The main body ECU controls the room light assembly.

WIRING DIAGRAM


E225983E01


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses and bulbs for circuits related to this system before performing the following inspection procedure.

1.PERFORM ACTIVE TEST USING TECHSTREAM
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Turn the room light assembly switch to the DOOR position.

  1. All doors closed (door courtesy light switches OFF).

  1. Enter the following menus: Body Electrical / Main Body / Active Test.

  1. According to the display on the Techstream, perform the Active Test.

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Illuminated Entry System
    Map light assembly
    ON or OFF
    Room light assembly (room light assembly switch in DOOR position, and all doors closed)

    OK:
    The illuminated entry system operates normally when operating it through the Techstream.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.INSPECT ROOM LIGHT ASSEMBLY
  1. Inspect the room light assembly (Click here).



NG
REPLACE ROOM LIGHT ASSEMBLY (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (ROOM LIGHT ASSEMBLY - BATTERY)


    E214733E03
  1. Disconnect the K2 room light assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    K2-1 - Body ground
    Always
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Room Light Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (ROOM LIGHT ASSEMBLY - MAIN BODY ECU)
  1. Disconnect the K2 room light assembly connector.

  1. Disconnect the 4K main body ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    K2-2 - 4K-2
    Always
    Below 1 Ω
    K2-2 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU