Home › Engine / Hybrid System › 1NZ-FE LUBRICATION › LUBRICATION SYSTEM (for Sedan)

LUBRICATION SYSTEM (for Sedan) > ON-VEHICLE INSPECTION



1. INSPECT ENGINE OIL QUALITY
  1. Check the engine oil for deterioration, water intrusion, discoloration or thinning.
    If the quality is visibly poor, replace the engine oil and oil filter.



2. INSPECT ENGINE OIL LEVEL
  1. Warm up the engine, then stop the engine and wait for 5 minutes.

  1. Check that the engine oil level is between the low and full marks on the engine oil level dipstick.
    If the engine oil level is low, check for oil leakage and add engine oil up to the full level mark.

    NOTICE:
    Do not add engine oil to above the full level mark.

    HINT:
    A certain amount of engine oil will be consumed while driving. In the following situations, oil consumption may increase, and engine oil may need to be refilled in between oil maintenance intervals.
    1. When the engine is new, for example directly after purchasing the vehicle or after replacing the engine.
    2. If low quality oil or oil of an inappropriate viscosity is used.
    3. When driving at high engine speed or with a heavy load, (when towing, or), when driving while accelerating or decelerating frequently.
    4. When leaving the idling for a long time, or when driving frequently through heavy traffic.
    When judging the amount of oil consumption, keep in mind that the oil may have become diluted, making it difficult to judge the true level accurately.



3. INSPECT ENGINE OIL PRESSURE
  1. Remove the engine oil pressure switch (Click here).



    A104878
  1. Install the oil pressure gauge.

  1. Warm up the engine.

  1. Check the engine oil pressure.

    Standard oil pressure:
    Engine rpm
    Oil Pressure
    When idling
    29 kPa (0.3 kgf/cm2, 4.3 psi) or more
    At 3000 rpm
    150 to 550 kPa (1.5 to 5.6 kgf/cm2, 22 to 80 psi) or more

    If the oil pressure is not specified, check the oil pump (Click here).

  1. Remove the oil pressure gauge.

  1. Install the engine oil pressure switch (Click here).



4. INSPECT FOR OIL LEAK