FUEL INJECTOR (for Sedan) > REMOVAL |
| 1. DISCHARGE FUEL SYSTEM PRESSURE |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE CYLINDER HEAD COVER NO. 2 |
![]() |
Remove the 4 nuts and cylinder head cover No. 2.
| 4. REMOVE IGNITION COIL NO. 1 |
![]() |
Disconnect the 4 ignition coil connectors.
![]() |
Remove the 4 bolts and 4 ignition coils.
| 5. DISCONNECT VENTILATION HOSE |
![]() |
Disconnect the ventilation hose.
| 6. DISCONNECT FUEL VAPOR FEED HOSE ASSEMBLY |
![]() |
Disconnect fuel vapor feed hose assembly.
| 7. REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY |
![]() |
Disconnect the fuel injector connectors.
![]() |
Disconnect the connector and 3 wire harness clamps shown in the illustration and disconnect the engine wire harness.
![]() |
Remove the bolt and remove the wire harness bracket.
![]() |
Remove the 9 bolts, 2 nuts and 2 seal washers and then remove the cylinder head cover sub-assembly.
Remove the gasket from the cylinder head cover sub-assembly.
| 8. DISCONNECT FUEL TUBE SUB-ASSEMBLY |
![]() |
Remove the fuel pipe clamp.
![]() |
Pinch the retainer of the fuel tube connector, then pull the fuel tube connector to disconnect the fuel tube out of the fuel delivery pipe sub-assembly.
| 9. REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY |
![]() |
Remove the 3 bolts and remove the fuel delivery pipe sub-assembly with 4 fuel injectors.
| 10. REMOVE DELIVERY PIPE NO. 1 SPACER |
![]() |
Remove the 2 delivery pipe No. 1 spacers.
| 11. REMOVE INJECTOR VIBRATION INSULATOR |
![]() |
Remove the 4 injector vibration insulators.
| 12. REMOVE FUEL INJECTOR ASSEMBLY |
![]() |
Pull the 4 fuel injector assemblies out of the fuel delivery pipe sub-assembly.