IGNITION SYSTEM (for Hatchback) > ON-VEHICLE INSPECTION |
| 1. PERFORM SPARK TEST |
Check for DTCs (Click here).
Remove the 4 ignition coils and 4 spark plugs (Click here).
![]() |
Disconnect the 4 injector connectors.
![]() |
Install a spark plug to each ignition coil and connect the ignition coil connectors.
Ground the spark plugs.
Check that spark occurs while the engine is being cranked.
Check whether sparks occur.
If spark does not occur, perform the following procedure.
| 2. INSPECT IGNITION COIL AND SPARK TEST |
Perform the spark test in accordance with the following procedure.
Check that the wire harness side connector of the ignition coil with igniter is securely connected.
| Result | Proceed to |
| NG | Connect securely |
| OK | Go to next step |
Perform a spark test on each ignition coil with igniter.
If there is a cylinder where sparks do not occur, replace its ignition coil with the ignition coil of a cylinder where sparks occur normally.
Crank the engine and visually check that sparks occur at the cylinder with the normally operating ignition coil.
| Result | Proceed to |
| NG | Replace ignition coil with igniter |
| OK | Go to next step |
Perform a spark test on each spark plug.
If there is a cylinder where sparks do not occur, replace its spark plug with the spark plug of a cylinder where sparks occur normally.
Crank the engine and visually check that sparks occur at the cylinder with the normally operating spark plug.
| Result | Proceed to |
| NG | Replace spark plug |
| OK | Ignition Circuit |
Connect the 4 injector connectors.
Install the ignition coil and spark plug (Click here).
| 3. INSPECT SPARK PLUG |
![]() |
Check the electrode.
| *1 | Body Ground |
Measure the insulation resistance.
Alternative inspection method:
Quickly accelerate the engine to 4000 rpm 5 times.
Remove the spark plug.
![]() |
Visually check the spark plug.
If the electrode is dry, the spark plug is functioning properly. If the electrode is damp, proceed to the next step.
Check the spark plug for any damage to its thread and insulator.
If there is any damage, replace the spark plug.
| Manufacturer | Product |
| DENSO | FK16HR11 |
Clean the spark plug.
If the electrode has traces of wet carbon, clean the electrode with a spark plug cleaner and then dry with compressed air.