Home
›
Vehicle Exterior
›
EXTERIOR PANELS / TRIM
›
FRONT DOOR BELT MOULDING (for Sedan)
FRONT DOOR BELT MOULDING (for Sedan) > INSTALLATION
HINT:
The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.
1. INSTALL FRONT DOOR BELT MOULDING
Engage the 6 claws and install a new front door belt moulding.
Remove the protective tape.
2. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY
(
Click here
)