Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT DOOR BELT MOULDING (for Sedan)

FRONT DOOR BELT MOULDING (for Sedan) > REMOVAL


HINT:
The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.



1. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY
(Click here)


2. REMOVE FRONT DOOR BELT MOULDING


    B134873E03
  1. Apply protective tape to the door panel in the periphery of the front door belt moulding.
    Text in Illustration 
    *a
    Protective Tape



    B134874
  1. Using a moulding remover, disengage the 6 claws and remove the front door belt moulding.