REAR AIRBAG SENSOR (for Hatchback 5 Door) > INSTALLATION |
| 1. INSTALL NO. 2 SIDE AIRBAG SENSOR ASSEMBLY |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Insert the pin (stopper) into the body hole to install the No. 2 side airbag sensor assembly to the vehicle with the bolt.
Connect the connector to the No. 2 side airbag sensor assembly.
Connect the connector as shown in the illustration (when locking, make sure that the outer connector locking sleeve returns to its original position and a click sound can be heard).

| *1 | Outer Connector Locking Sleeve | - | - |
| *a | Slide | - | - |
Check that there is no looseness in the installation parts of the No. 2 side airbag sensor assembly.
| 2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH (for RH Side) |
Engage the 3 clips.
Engage the guide and the 4 claws and install the deck trim side panel.
Install the 3 screws.
| 3. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH (for LH Side) |
| 4. INSTALL REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY |
Engage the 2 claws and install the rear seat 3 point type outer belt.
Tighten the bolt.
| 5. CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP |
![]() |
Align the paint mark on the rear door opening trim weatherstrip with the flange position on the vehicle body and install the weatherstrip.
| *a | Paint Mark |
| *b | Flange Position |
| Area | Color |
| RH Side | Purple |
| LH Side | Pink |
| 6. INSTALL REAR DOOR SCUFF PLATE |
Engage the guide and the 5 claws and install the rear door scuff plate.
| 7. INSTALL REAR FLOOR FINISH PLATE |
Engage the 4 guides and the 4 claws to install the rear floor finish plate.
| 8. INSTALL JACK HANDLE (for RH Side) |
| 9. INSTALL NO. 2 ROOM LIGHT ASSEMBLY (for LH Side) |
![]() |
Connect the connector.
Engage the claw to install the No. 2 room light assembly.
| 10. INSTALL DECK BOARD ASSEMBLY |
Install the deck board.
| 11. INSTALL REAR SEAT ASSEMBLY (for Fold Down Seat Type) |
| 12. INSTALL REAR SEAT ASSEMBLY (for 60/40 Split Seat Type LH Side) |
| 13. INSTALL REAR SEAT ASSEMBLY (for 60/40 Split Seat Type RH Side) |
| 14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 15. INSPECT SRS WARNING LIGHT |