Home › Drivetrain ยท AXLE AND DIFFERENTIAL › STEERING KNUCKLE (for Hatchback)

STEERING KNUCKLE (for Hatchback) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side as for the LH side.
  2. The procedure listed below is for the LH side.



1. REMOVE FRONT AXLE ASSEMBLY
(Click here)


2. REMOVE FRONT AXLE HUB HOLE SNAP RING


    C202595
  1. Using snap ring pliers, remove the axle hub hole snap ring.

    NOTICE:
    When removing the hole snap ring, do not damage the magnetic rotor surface.



3. REMOVE FRONT AXLE HUB SUB-ASSEMBLY


    C057871E01
  1. Fix the steering knuckle in a vise between aluminum plates.

    NOTICE:
    Do not overtighten the vise.

  1. Using SST, remove the axle hub.

    SST
    09520-00031  



    C202597E02
  1. Using SST, remove the axle hub bearing inner race.
    Text in Illustration 
    *a
    Hold
    *b
    Turn

    SST
    09950-40011   (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04011, 09957-04010, 09958-04011)
    09950-60010   (09951-00370)

    NOTICE:
    1. When removing the inner race, it the axle hub is damaged, replace the axle hub with a new one.
    2. Apply a small amount of grease to the threads and tip of SST before use.



4. REMOVE FRONT DISC BRAKE DUST COVER


    C107919
  1. Remove the disc brake dust cover by tapping the back side with a brass bar and hammer.



5. REMOVE FRONT AXLE HUB BEARING


C112580E01
  1. Install the removed axle hub bearing inner race onto the outer side of the axle hub bearing.

  1. Using SST and a press, remove the axle hub bearing.

    SST
    09223-15020  
    09387-02010  
    09950-60010   (09951-00630)
    09950-70010   (09951-07100)