FRONT AXLE HUB (for Hatchback) > INSTALLATION |
| 1. INSTALL FRONT AXLE HUB BEARING |
| 2. INSTALL FRONT AXLE HUB SUB-ASSEMBLY |
![]() |
Using SST and a press, press the axle hub into the steering knuckle.
| 3. INSTALL FRONT AXLE HUB HOLE SNAP RING |
![]() |
Using snap ring pliers, install a new axle hub hole snap ring, as shown in the illustration.
| *1 | Snap Ring Pliers |
| *a | Speed Sensor Installation Gap |
| 4. INSTALL FRONT AXLE ASSEMBLY |
Align the drive shaft splines and install the axle assembly.
![]() |
Install the front axle assembly onto the shock absorber with the 2 bolts and 2 nuts.
| 5. INSTALL FRONT LOWER SUSPENSION ARM |
Install the lower arm onto the steering knuckle with a new castle nut.
Install a new clip.
| 6. INSTALL TIE ROD END SUB-ASSEMBLY |
Install the tie rod end sub-assembly onto the steering knuckle with a new castle nut.
Install a new cotter pin.
| 7. INSTALL FRONT STABILIZER LINK ASSEMBLY |
Install the front stabilizer link assembly with the nut.
| 8. INSTALL FRONT SPEED SENSOR (w/ ABS) |
Install the speed sensor onto the steering knuckle with the bolt.
Install the front flexible hose and speed sensor to the front shock absorber with the bolt.
| 9. INSTALL FRONT FLEXIBLE HOSE |
Install the front flexible hose to the front shock absorber with the bolt.
| 10. INSPECT FRONT AXLE HUB BEARING BACKLASH |
![]() |
Using a dial indicator, check the backlash near the center of the axle hub.
| 11. INSPECT FRONT AXLE HUB RUNOUT |
![]() |
Using a dial indicator, check the runout of the surface of the axle hub.
| 12. INSTALL FRONT DISC |
![]() |
Align the matchmarks of the disc and axle hub and install the disc.
| *a | Matchmark |
| 13. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY |
Install the disc brake caliper onto the steering knuckle.
| 14. INSTALL FRONT AXLE SHAFT NUT |
Clean the threaded parts on the front drive shaft and axle shaft nut using a non-residue solvent.
Using a deep socket wrench 30 mm, install a new front axle shaft nut.
![]() |
Using a chisel and hammer, stake the axle shaft nut.
| 15. INSTALL FRONT WHEEL |
| 16. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT |
| 17. CHECK SPEED SENSOR SIGNAL (w/ ABS) |
| 18. CHECK SPEED SENSOR SIGNAL (w/ VSC) |