Home › Drivetrain ยท AXLE AND DIFFERENTIAL › REAR AXLE HUB (for Sedan)

REAR AXLE HUB (for Sedan) > INSTALLATION



1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY
  1. Install the axle hub and bearing to the axle beam with the 4 bolts.

    Torque:
    90 N*m{ 918 kgf*cm , 67 ft.*lbf }



2. INSPECT REAR AXLE HUB BEARING


C121815
  1. Inspect the axle hub and bearing backlash.

    1. Using a dial indicator, check the backlash near the center of the axle hub.

      Maximum:
      0.05 mm (0.0020 in.)

      If the backlash exceeds the maximum, replace the axle hub and bearing.



    C121816
  1. Inspect the axle hub and bearing runout.

    1. Using a dial indicator, check the runout of the surface of the axle hub.

      Maximum:
      0.07 mm (0.0028 in.)

      If the runout exceeds the maximum, replace the axle hub and bearing.



3. CONNECT SKID CONTROL SENSOR WIRE (w/ ABS)


C107565
  1. Connect the skid control sensor wire connector.



4. INSTALL REAR BRAKE DRUM SUB-ASSEMBLY


5. ADJUST REAR DRUM BRAKE SHOE CLEARANCE
  1. Provisionally install the 2 hub nuts.



    F040023E07
  1. Remove the hole plug, and turn the adjuster to expand the shoe until the drum locks.
    Text in Illustration 
    *1
    Automatic Adjust Lever
    V100135
    Expand

  1. Using a screwdriver, release the adjuster 12 notches.

  1. Install the hole plug.



6. INSTALL REAR WHEEL

Torque:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }



7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



8. CHECK ABS SENSOR SIGNAL (w/ ABS)
(Click here)