Home › Engine / Hybrid System › 1NZ-FE FUEL › FUEL TANK (for Sedan)

FUEL TANK (for Sedan) > INSTALLATION



1. INSTALL FUEL TANK ASSEMBLY


A119177
  1. Install the fuel tank main tube onto the fuel tank.

  1. Clean the bolt hole and remove any grease.



    A115469
  1. Install the fuel tank with 4 new bolts.

    Torque:
    14 N*m{ 146 kgf*cm , 10 ft.*lbf }



2. CONNECT FUEL TANK FILLER PIPE SUB-ASSEMBLY LOWER


A119174
  1. Connect the fuel tank filler pipe and install the clamp.



3. CONNECT FUEL TANK BREATHER TUBE


A119155
  1. Align the fuel tank breather tube connector with the pipe, push the fuel tube connector in until the retainer makes a click sound, then lock the cover of the connector.

    NOTICE:
    1. Check that there are no scratches or foreign matter on the disconnected parts of the fuel tank breather tube connector and pipe before performing this work.
    2. After connecting, pull the pipe and fuel tank breather connector to make sure that they are securely connected.



4. CONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY


A119154
  1. Align the fuel tube connector with the pipe, push the fuel tube connector in until the retainer makes a click sound, then lock the cover of the connector.

    NOTICE:
    1. Check that there are no scratches or foreign matter on the disconnected parts of the fuel tube connector and pipe before performing this work.
    1. After connecting, pull the pipe and fuel tube connector to make sure that they are securely connected.



5. INSTALL FUEL TANK PROTECTOR SUB-ASSEMBLY


A115471
  1. Install the fuel tank protector sub-assembly with the bolt and clip.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



6. INSTALL FRONT FLOOR HEAT INSULATOR NO. 4


A115470
  1. Install the 2 nuts.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



7. INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY
  1. Install the fuel suction with pump and gauge tube assembly (Click here).



8. ADD FUEL