Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM (for Sedan)

DTC    B1269    Theft Deterrent ECU Communication Stop


DESCRIPTION

DTC B1269 is output when the communication between the theft warning ECU (theft deterrent ECU) and the main body ECU stops for more than 10 seconds.

DTC Code.
DTC Detection Condition
Trouble Area
B1269
No communication from theft warning ECU for more than 10 seconds.
  1. Theft warning ECU assembly
  2. Wire harness and connector

WIRING DIAGRAM


B121325E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (THEFT WARNING ECU ASSEMBLY - MAIN BODY ECU)


    B121326E01
  1. Disconnect the D26 theft warning ECU and D33 main body ECU connectors.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    D26-24 (BRK+) - D33-18 (SRX)
    Below 1 Ω
    D26-25 (BRK-) - D33-19 (STX)
    Below 1 Ω
    D26-24 (BRK+) or D33-18 (SRX) - Body ground
    10 kΩ or higher
    D26-25 (BRK-) or D33-19 (STX) - Body ground
    10 kΩ or higher
    D26-16 (E) - Body ground
    Below 1 Ω

  1. Reconnect the theft warning ECU and main body ECU connectors.



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (BATTERY VOLTAGE)
B121327E01
  1. Disconnect the D26 theft warning ECU connector.

  1. Check the voltage between the wire harness side connector and body ground.

    Standard voltage:
    Tester Connection
    Specified Condition
    D26-11 (+B1) - Body ground
    11 to 14 V
    D26-13 (+B2) - Body ground
    11 to 14 V

  1. Reconnect the theft warning ECU connector.



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE THEFT WARNING ECU ASSEMBLY (Click here)