CAN COMMUNICATION SYSTEM (for Hatchback) > Center Airbag Sensor Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Airbag Sensor Communication Stop Mode | Either condition is met:
|
|

| 1.CHECK FOR OPEN IN CAN BUS WIRE (AIRBAG SENSOR ASSEMBLY BRANCH WIRE) |
![]() |
Disconnect the D112 airbag sensor assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D112-13 (CANH) - D112-22 (CANL) | Ignition switch off | 54 to 69 Ω |
| *a | Front view of wire harness connector (to Airbag Sensor Assembly) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT) |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D112-21 (IG2) - Body ground | Ignition switch ON | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D112-25 (E1) - Body ground | Always | Below 1 Ω |
| D112-26 (E2) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Airbag Sensor Assembly) |
|
| ||||
| OK | ||
| ||