CAN COMMUNICATION SYSTEM (for Sedan) > Brake Actuator (Skid Control ECU) Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Brake Actuator (Skid Control ECU) Communication Stop Mode |
|
|

| 1.CHECK CAN BUS LINE FOR DISCONNECTION (BRAKE ACTUATOR (SKID CONTROL ECU) BRANCH WIRE) |
![]() |
Turn the ignition switch off.
Disconnect the A15 brake actuator (skid control ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A15-25 (CANH) - A15-14 (CANL) | Ignition switch off | 54 to 69 Ω |
| *a | Front view of wire harness connector (to Brake Actuator (Skid Control ECU)) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (IG1, GND1, GND2) |
![]() |
Disconnect the A15 brake actuator (skid control ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A15-13 (GND2) - Body ground | Always | Below 1 Ω |
| A15-1 (GND1) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A15-34 (IG1) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector (to Brake Actuator (Skid Control ECU)) |
|
| ||||
| OK | ||
| ||