FRONT SEAT ASSEMBLY (for Hatchback Driver Side) > INSTALLATION |
| 1. INSTALL FRONT SEAT ASSEMBLY |
![]() |
Insert the 2 location pins of the front seat assembly through the 2 body holes, place the front seat assembly in the foremost position and make sure that the inner and outer seat tracks are locked securely.
Using an E10 "TORX" socket wrench, install bolt (1) and then bolt (2) onto the rear side.
Move the front seat assembly to the rearmost position, and then make sure that the inner and outer seat tracks are securely locked.
Using an E10 "TORX" socket wrench, install bolt (3) and then bolt (4) onto the front side.
Make sure that the inner and outer seat tracks lock simultaneously after the seat is moved.
Connect the seat airbag sub-assembly connector. (w/ Front Seat Side Airbag)
Connect the seat airbag assembly connector. (w/ Front Seat Side Airbag)
Connect the buckle switch connector.
Engage the clamp.
| 2. INSTALL SEAT TRACK OUTER COVER |
Move the front seat assembly to the foremost position.
Engage the 2 claws to install the seat track outer cover.
| 3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Front Seat Side Airbag) |
| 4. INSPECT SRS WARNING LIGHT (w/ Front Seat Side Airbag) |