Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY (for Hatchback Front Passenger Side)

FRONT SEAT ASSEMBLY (for Hatchback Front Passenger Side) > INSTALLATION


CAUTION:
  1. Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here). (w/ Front Seat Side Airbag)
  2. If the front seat airbag assembly was deployed, replace the front seat airbag assembly, separate type front seatback spring assembly, separate type front seatback cover and separate type front seatback pad with a new one. (w/ Front Seat Side Airbag)
  3. If the front seat airbag sub-assembly was deployed, replace the seat airbag sub-assembly, separate type front seat cushion spring assembly, separate type front seat cushion cover and separate type front seat cushion pad with a new one. (w/ Front Seat Side Airbag)

NOTICE:
Always use E10 "TORX" socket wrench when removing the front seat.



1. INSTALL FRONT SEAT ASSEMBLY


B289323E02

NOTICE:
  1. Follow the procedure described below in order to prevent the seat tracks from locking separately.
  2. Be careful not to damage the vehicle body.

  1. Insert the 2 location pins of the front seat assembly through the 2 body holes, place the front seat assembly in the foremost position and make sure that the inner and outer seat tracks are locked securely.

  1. Using an E10 "TORX" socket wrench, install bolt (1) and then bolt (2) onto the rear side.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

  1. Move the front seat assembly to the rearmost position, and then make sure that the inner and outer seat tracks are securely locked.

  1. Using an E10 "TORX" socket wrench, install bolt (3) and then bolt (4) onto the front side.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

  1. Make sure that the inner and outer seat tracks lock simultaneously after the seat is moved.

    HINT:
    If the inner and outer seat tracks do not lock simultaneously, loosen the bolts and adjust the seat tracks.

  1. Connect the front seat airbag sub-assembly connector. (w/ Front Seat Side Airbag)

  1. Connect the front seat airbag assembly connector. (w/ Front Seat Side Airbag)

  1. Connect the occupant detection connector.



2. INSTALL SEAT TRACK OUTER COVER
  1. Move the front seat assembly to the foremost position.

  1. Engage the 2 claws to install the seat track outer cover.



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Front Seat Side Airbag)

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



4. INSPECT SRS WARNING LIGHT (w/ Front Seat Side Airbag)
(Click here)