Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY (for Hatchback Driver Side)

FRONT SEAT ASSEMBLY (for Hatchback Driver Side) > REMOVAL


Click here


1. PRECAUTION (w/ Front Seat Side Airbag)

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Front Seat Side Airbag)

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE SEAT TRACK OUTER COVER
  1. Move the front seat assembly to the foremost position.



    B272740
  1. Disengage the 2 claws to remove the seat track outer cover.



4. REMOVE FRONT SEAT ASSEMBLY
  1. Disengage the clamp.

  1. Disconnect the buckle switch connector.



  1. Disconnect the front seat airbag assembly connector. (w/ Front Seat Side Airbag)



    1. Push the slider with a finger to disengage the first claw. Without releasing your finger, slide the slider to disengage the second claw and disconnect the front seat airbag assembly connector.


      B273982E05


      Text in Illustration 
      *1
      Slider
      -
      -
      *a
      Push
      *b
      Slide



  1. Disconnect the front seat airbag sub-assembly connector. (w/ Front Seat Side Airbag)



    1. Place a finger on the slider, slide the slider to release the lock, and then disconnect the front seat airbag sub-assembly connector.


      B273981E02


      Text in Illustration 
      *1
      Slider
      -
      -
      *a
      Push
      *b
      Slide



    B283297
  1. Using an E10 "TORX" socket wrench, remove the 2 bolts on the rear side of the front seat assembly.

  1. Move the front seat assembly to the rearmost position.

  1. Using an E10 "TORX" socket wrench, remove the 2 bolts on the front side of the front seat assembly.

  1. Lift up the seat track adjusting handle. (w/ Vertical Adjuster)

  1. Remove the front seat assembly.

    NOTICE:
    Be careful not to damage the vehicle body.