Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM (for Hatchback)

METER / GAUGE SYSTEM (for Hatchback) > Malfunction in Water Temperature Warning Light


DESCRIPTION

In this circuit, the meter CPU receives engine coolant temperature signals from the ECM using the CAN communication system (CAN V1 Bus). The meter CPU displays engine coolant temperature that is calculated based on the data received from the ECM.

WIRING DIAGRAM


E143765E55


INSPECTION PROCEDURE

HINT:
If there is an open or short in the engine coolant temperature sensor circuit, the ECM stores the DTCs. Troubleshoot the SFI System (Click here).

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check if a CAN communication DTC is output (Click here).
    Result 
    Result
    Proceed to
    CAN communication DTC is not output
    A
    CAN communication DTC is output
    B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2.PERFORM ACTIVE TEST USING TECHSTREAM (COOLANT TEMP)
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Body Electrical / Combination Meter / Active Test.

  1. According to the display on the Techstream, perform the Active Test.

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Indicat. Lamp Coolant Cool
    Engine coolant temperature indicator light
    OFF/ON
    Vehicle is stopped and engine is idling
    Indicat. Lamp Coolant Hot
    Engine coolant temperature warning light
    OFF/ON
    Vehicle is stopped and engine is idling

    OK:
    Value selected during Active Test is displayed.



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK


3.READ VALUE USING TECHSTREAM (COOLANT TEMPERATURE)
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Body Electrical / Combination Meter / Data List.

  1. According to the display on the Techstream, read the Data List.

    Combination Meter 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Coolant Temperature
    Engine coolant temperature/
    Min.: 0 (32)
    Max.: 127.5 (261.5)
    After warming up:
    80 to 100 (176 to 212)
    Unit: °C (°F)

    OK:
    Vehicle's coolant temperature and tester value are the same.



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK


4.CHECK ENGINE CONTROL SYSTEM
  1. Check if a engine control DTC is output (Click here).
    Result 
    Result
    Proceed to
    Engine control DTC is not output
    A
    Engine control DTC is output
    B



B
GO TO SFI SYSTEM (Click here)
A

REPLACE COMBINATION METER ASSEMBLY (Click here)