FUEL TANK (for Hatchback) > REMOVAL |
| 1. PRECAUTION |
![]() |
When removing and storing the fuel tank assembly, arrange the inlet hose as shown in the illustration, and secure the fuel tank assembly using a cord or similar.
| *1 | Cord |
| 2. REMOVE FUEL SUCTION TUBE ASSEMBLY WITH PUMP AND GAUGE |
| 3. DRAIN FUEL |
| 4. REMOVE REAR CONSOLE BOX ASSEMBLY |
| 5. REMOVE FRONT FLOOR CENTER BRACE |
![]() |
Remove the 2 bolts and the front floor center brace from the body.
| 6. REMOVE FRONT EXHAUST PIPE ASSEMBLY |
![]() |
Peel back the floor carpet.
![]() |
Disconnect the heated oxygen sensor connector.
Remove the oxygen sensor wire grommet and pass the connector through the hole to the outside of the vehicle.
![]() |
Remove the 2 bolts and 2 compression springs from the exhaust manifold.
![]() |
Remove the 2 bolts and 2 compression springs from the tail exhaust pipe assembly.
Remove the 3 exhaust pipe supports and the front exhaust pipe assembly.
| 7. REMOVE EXHAUST PIPE GASKET |
Remove the exhaust pipe gasket from the exhaust manifold.
| 8. REMOVE NO. 2 EXHAUST PIPE GASKET |
Remove the No. 2 exhaust pipe gasket from the front exhaust pipe assembly.
| 9. REMOVE FRONT NO. 4 FLOOR HEAT INSULATOR |
![]() |
Remove the 2 nuts and the front No. 4 floor heat insulator.
| 10. REMOVE FUEL TANK COVER VENT CASE SUB-ASSEMBLY |
![]() |
Pinch and remove the clip as shown in the illustration.
Remove the bolt and the fuel tank cover vent case sub-assembly.
| 11. DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY |
![]() |
Disengage the fuel tube connector cover.
| *1 | Retainer |
| *2 | O-ring |
| *3 | Fuel Tube Connector |
Pinch the retainer by hand from both sides, and pull out the fuel tube connector from the pipe.
| 12. DISCONNECT FUEL TANK VENT HOSE |
![]() |
Release the retainer as shown in the illustration and disconnect the fuel tank vent hose sub-assembly.
| *1 | Retainer |
![]() | Push |
![]() | Pull |
| 13. REMOVE FUEL TANK ASSEMBLY |
![]() |
Remove the bolt, disengage the claw and separate the fuel tank filler pipe assembly.
Using an engine lifter, support the fuel tank assembly.
![]() |
Remove the bolt and separate the parking brake cable.
![]() |
Remove the 4 bolts and fuel tank assembly.
| 14. REMOVE FUEL TANK MAIN TUBE SUB-ASSEMBLY |
![]() |
Remove the fuel tank main tube from the fuel tank assembly.
| 15. REMOVE FUEL TANK VENT HOSE |
![]() |
Remove the fuel tank vent hose sub-assembly from the fuel tank assembly.
| 16. REMOVE FUEL TANK FILLER PIPE PROTECTOR |
![]() |
Remove the clip from the fuel tank filler pipe protector.
Disengage the 2 claws and remove the No. 2 fuel tube support protector.
Disengage the 2 claws and remove the fuel tank filler pipe protector.
| 17. REMOVE BREATHER TUBE CLAMP |
![]() |
Disengage the claw and clamp as shown in the illustration, and remove the breather tube clamp.