THEFT DETERRENT SYSTEM (for Hatchback) > Ignition Switch Circuit |

| 1.READ VALUE USING TECHSTREAM |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Main Body / Data List.
According to the display on the Techstream, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| ACC SW | Ignition switch / OFF or ON | OFF: Ignition switch LOCK or ON ON: Ignition switch ACC | - |
| IG SW | Ignition switch / OFF or ON | OFF: Ignition switch LOCK or ACC ON: Ignition switch ON | - |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (BATTERY - INSTRUMENT PANEL JUNCTION BLOCK) |
![]() |
Disconnect the 3E junction block connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 3E-1 - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector (to Instrument Panel Junction Block) |
|
| ||||
| OK | |
| 3.INSPECT IGNITION OR START SWITCH ASSEMBLY |
Inspect the ignition or start switch assembly (Click here).
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (IGNITION OR START SWITCH ASSEMBLY - INSTRUMENT PANEL JUNCTION BLOCK) |
Reinstall the ignition or start switch assembly.
Disconnect the 3A and 3B junction block connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 3A-29 - 3B-40 | Ignition switch ON | Below 1 Ω |
| 3B-37 - 3D-40 | Ignition switch ACC | Below 1 Ω |
| 3D-8 - Body Ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||