FRONT SEAT OUTER BELT ASSEMBLY (for Hatchback 5 Door) > INSTALLATION |
| 1. INSTALL FRONT SEAT OUTER BELT ASSEMBLY |
![]() |
Check the angle of inclination required to lock the retractor.
Gently incline the retractor from its initial position. Check that the belt does not lock when the retractor is inclined 15° or less in any direction. Also, check that the belt locks when the inclination of the retractor is 45° or more.
| *a | Unlock |
| *b | Lock |
![]() |
Engage the 2 hooks and temporarily install the front seat outer belt assembly with the 2 bolts.
Tighten bolt A and then bolt B.
![]() |
Connect the pretensioner connector.
| *1 | Locking Button |
Lock the locking button.
Connect the shoulder anchor part of the front seat outer belt assembly with the bolt.
Connect the floor anchor part of the front seat outer belt assembly with the bolt.
Check that the ELR locks.
With the belt installed, check that the belt locks when it is pulled out quickly.
If the operation is not as specified, replace the front seat outer belt assembly.
Remove the bolt to disconnect the floor anchor part of the front seat outer belt assembly.
| 2. INSTALL CENTER PILLAR UPPER GARNISH |
Pass the front seat outer belt through the slit in the center pillar upper garnish.
Engage the clip and install the center pillar upper garnish with 2 screws.
| 3. CONNECT FRONT SEAT OUTER BELT ASSEMBLY |
Connect the floor anchor part of the front seat outer belt assembly with the bolt.
Engage the 3 claws to install the lap belt outer anchor cover.
| 4. INSTALL CENTER PILLAR LOWER GARNISH |
Engage the 2 clips and the 2 claws.
Engage the 2 guides and install the center pillar lower garnish.
| 5. CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP |
![]() |
Align the paint mark on the rear door opening trim weatherstrip with the flange position on the vehicle body and install the weatherstrip.
| *a | Paint Mark |
| *b | Flange Position |
| Area | Color |
| RH Side | Purple |
| LH Side | Pink |
| 6. CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP |
![]() |
Align the paint mark on the front door opening trim weatherstrip with the flange position on the vehicle body and install the weatherstrip.
| *a | Paint Mark |
| *b | Flange Position |
| Area | Color |
| RH Side | Gold |
| LH Side | Silver |
| 7. INSTALL REAR DOOR SCUFF PLATE |
Engage the guide and the 5 claws and install the rear door scuff plate.
| 8. INSTALL FRONT DOOR SCUFF PLATE |
Engage the 8 claws and install the front door scuff plate.
| 9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 10. INSPECT SRS WARNING LIGHT |