Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW REGULATOR MOTOR (for Sedan Front Side)

POWER WINDOW REGULATOR MOTOR (for Sedan Front Side) > INSTALLATION



1. INSTALL FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY


B127213
  1. Apply MP grease to the sliding and rotating areas of the front power window regulator motor.

  1. Using a T25 "TORX" socket wrench, install the front power window regulator motor assembly with the 3 screws.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



2. INSTALL FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY
  1. Apply MP grease to the sliding and rotating areas of the front door window regulator sub-assembly.

    NOTICE:
    Do not apply grease to the window regulator spring.



    B351471E01
  1. Temporarily install the bolt A onto the front door window regulator sub-assembly.

  1. Insert the front door window regulator sub-assembly into the door panel. Use bolt A to hang the front door window regulator sub-assembly on the door panel.

    NOTICE:
    Do not drop the front door window regulator sub-assembly as it may be damaged.

  1. Install the front door window regulator sub-assembly with the 5 bolts and tighten the bolt A.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Connect the connector.



3. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY


B351480E01
  1. Insert the front door glass sub-assembly into the door panel along the front door glass run as indicated by the arrows in the order shown in the illustration.

    NOTICE:
    Do not damage the front door glass sub-assembly.



    B351469
  1. Install the front door glass sub-assembly onto the front door window regulator sub-assembly with the 2 bolts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }



4. INSTALL FRONT DOOR SERVICE HOLE COVER


B136187E01
  1. Apply butyl tape to the door panel, then install a new front door service hole cover as shown in the illustration.

    Specification:
    Area
    Dimension
    A
    2.0 mm (0.079 in.) or more
    B
    6.0 mm (0.236 in.) or more

    HINT:
    1. When installing the front door service hole cover, pull the links and connectors out through the service hole.
    2. There should be no wrinkles or folds after attaching the front door service hole cover.
    3. After attaching the front door service hole cover, check the quality of the seal.

  1. Connect the connectors and clamps.



5. INSTALL FRONT DOOR TRIM BRACKET


    B136164
  1. Install the front door trim bracket with the 2 screws.



6. INSTALL FRONT DOOR BELT MOULDING
(Click here)


7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }