Home › Vehicle Interior › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY (for Sedan)

FRONT SEAT INNER BELT ASSEMBLY (for Sedan) > REMOVAL


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).

NOTICE:
Always use "Torx" socket wrench E10 when removing the front seat.

HINT:
The procedure described below is for the driver side. Use the same procedure for both the front passenger and driver sides, unless otherwise specified.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.



2. REMOVE FRONT SEAT HEADREST ASSEMBLY


    B138314E02
  1. Push in the lock button of the front seat headrest support and remove the front seat headrest.
    Text in Illustration 
    *1
    Lock Button



3. REMOVE FRONT SEAT ASSEMBLY


    B209187
  1. Disconnect the buckle switch connector.



    B138317
  1. Move the front seat to its most rearward position.

  1. Using an E10 "TORX" socket wrench, remove the 2 bolts from the front side.

  1. Move the front seat to its most forward position.

  1. Using an E10 "TORX" socket wrench, remove the 2 bolts from the rear side.

  1. Remove the front seat.



4. REMOVE FRONT SEAT INNER BELT ASSEMBLY


    B138569
  1. for Driver Side:

    1. Disconnect the seat position sensor connector.

    2. Using a clip remover, remove the connector.

    3. Using a clip remover, remove the clamp.

    4. Remove the clamp.



    B138570
  1. for Front Passenger Seat:

    1. Using a clip remover, remove the connector.

    2. Using a clip remover, remove the clamp.

    3. Remove the clamp.



    B138351
  1. Remove the wire harness from the claw of the front seat cushion inner shield.

  1. Remove the nut and the front seat inner belt.