Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM (for Hatchback)

DTC    B1500    Fuel Sender Open Detected


DESCRIPTION

This DTC is output when the combination meter assembly detects a fuel sender gauge malfunction.

DTC No.
DTC Detection Condition
Trouble Area
B1500
When combination meter detects fuel sender gauge malfunction
  1. Harness or connector
  2. Combination meter assembly
  3. Fuel suction with pump and gauge assembly
  4. Fuel sender gauge assembly

WIRING DIAGRAM


E219770E03


INSPECTION PROCEDURE

1.INSPECT FUEL SENDER GAUGE ASSEMBLY


  1. Remove the fuel sender gauge assembly (Click here).


    E226985E01


Text in Illustration 
*a
Component without harness connected
(Fuel Sender Gauge Assembly)
-
-
  1. Check that the float moves smoothly between F and E.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:

    Tester Connection
    Float Level
    Float Position (mm (in.))
    Specified Condition
    1 - 2
    F
    142 to 152 (5.591 to 5.984)
    13.5 to 16.5 Ω
    1/2
    71.1 to 76.1 (2.799 to 2.996)
    208.3 Ω
    Warning
    5.9 to 10.9 (0.232 to 0.429)
    365.2 Ω
    E
    0 (0)
    405.5 to 414.5 Ω

  1. Reinstall the fuel sender gauge assembly.



NG
REPLACE FUEL SENDER GAUGE ASSEMBLY (Click here)
OK


2.INSPECT FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY


    E158805E09
  1. Remove the fuel suction with pump and gauge tube assembly .

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A-2 (FS) - B-2
    Always
    Below 1 Ω
    A-3 (FE) - B-1
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (Fuel Suction with Pump and Gauge Tube Assembly)
    *b
    Connector A
    *c
    Connector B

  1. Reinstall the fuel suction plate sub-assembly.



NG
REPLACE FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY
OK


3.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY)
  1. Disconnect the D100 combination meter assembly connector.

  1. Disconnect the J71 fuel suction with pump and gauge tube assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D100-16 (L) - J71-2 (FS)
    Always
    Below 1 Ω
    D100-16 (L) - Body ground
    Always
    10 kΩ or higher
    J71-3 (FE) - Body ground
    Always
    Below 1 Ω

  1. Reconnect the fuel suction with pump and gauge tube assembly connector.

  1. Reconnect the combination meter assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)