CAN COMMUNICATION SYSTEM (for Hatchback) > Steering Angle Sensor Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Steering Angle Sensor Communication Stop Mode | Either condition is met:
|
|

| 1.CHECK FOR OPEN IN CAN BUS WIRE (STEERING ANGLE SENSOR (SPIRAL CABLE SUB-ASSEMBLY) BRANCH WIRE) |
![]() |
Disconnect the D122 steering angle sensor (spiral cable sub-assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D122-4 (CANH) - D122-3 (CANL) | Ignition switch off | 54 to 69 Ω |
| *a | Front view of wire harness connector (to Steering Angle Sensor (Spiral Cable Sub-assembly)) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT) |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D122-5 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| D122-6 (BAT) - Body ground | Always | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D122-2 (ESS) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Steering Angle Sensor (Spiral Cable Sub-assembly)) |
|
| ||||
| OK | ||
| ||