Home › Vehicle Interior › DOOR LOCK › DOOR CONTROL RECEIVER (for Hatchback 5 Door)

DOOR CONTROL RECEIVER (for Hatchback 5 Door) > INSTALLATION



1. INSTALL DOOR CONTROL RECEIVER
  1. Engage the 2 hooks.

  1. Install the door control receiver with the bolt.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

  1. Connect the connector.



2. INSTALL ROOF SIDE INNER GARNISH LH

HINT:
Use the same procedure as for the RH side



3. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH

HINT:
Use the same procedure as for the RH side



4. INSTALL NO. 2 ROOM LIGHT ASSEMBLY


    E222046
  1. Connect the connector.

  1. Engage the claw to install the No. 2 room light assembly.



5. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH
  1. Install the rear door opening trim weatherstrip.



6. INSTALL REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY LH

HINT:
Use the same procedure as for the RH side



7. INSTALL REAR FLOOR FINISH PLATE
  1. Engage the 4 guides and the 4 claws to install the rear floor finish plate.



8. INSTALL REAR DOOR SCUFF PLATE LH

HINT:
Use the same procedure as for the RH side .



9. INSTALL REAR SEAT ASSEMBLY (for 60/40 Split Seat Type LH Side)
(Click here)


10. INSTALL REAR SEAT ASSEMBLY (for 60/40 Split Seat Type RH Side)
(Click here)


11. INSTALL REAR SEAT ASSEMBLY (for Fold Down Seat Type)
(Click here)


12. INSTALL DECK BOARD ASSEMBLY
  1. Install the deck board.