REAR CRANKSHAFT OIL SEAL (for Hatchback) > INSTALLATION |
| 1. INSTALL REAR ENGINE OIL SEAL |
Apply MP grease to the lip of a new oil seal.
![]() |
Using SST and hammer, tap in the oil seal until its surface is flush with the cylinder block and oil pan.
| 2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transaxle) |
Hold the crankshaft with SST.
Clean the 6 bolts and their holes.
![]() |
Apply adhesive to the 2 or 3 end threads of the bolt.
| *1 | Adhesive |
![]() |
Install the rear drive plate spacer, drive plate and ring gear sub-assembly, and front drive plate spacer with the 6 bolts.
| *1 | Front Drive Plate Spacer |
| *2 | Drive Plate and Ring Gear |
| *3 | Rear Drive Plate Spacer |
| *a | Engine Side |
| *b | Transaxle Side |
![]() |
Install and uniformly tighten the 6 bolts in several steps, in the sequence shown in the illustration.
| 3. INSTALL FLYWHEEL SUB-ASSEMBLY (for Manual Transaxle) |
Hold the crankshaft with SST.
Clean the 6 bolts and their holes.
![]() |
Apply adhesive to the 2 or 3 end threads of bolt.
| *1 | Adhesive |
Install the flywheel with the 6 bolts.
![]() |
Install the flywheel with the 6 bolts in the order shown in the illustration.
Mark paint marks on the bolt heads on the engine upper side.
![]() |
Tighten the bolts 90° in the sequence order shown in the illustration.
| 4. INSTALL CLUTCH DISC ASSEMBLY (for Manual Transaxle) |
![]() |
Insert SST into the clutch disc assembly, then insert them both into the flywheel sub-assembly.
| *a | Flywheel Side |
| 5. INSTALL CLUTCH COVER ASSEMBLY (for Manual Transaxle) |
![]() |
Align the matchmark on the clutch cover assembly with that on the flywheel sub-assembly.
| *a | Temporally |
| *b | Matchmark |
Following the procedures shown in the illustration, tighten the 6 bolts in order, starting with the bolt located near the knock pin at the top.
| 6. INSPECT AND ADJUST CLUTCH COVER ASSEMBLY (for Manual Transaxle) |
![]() |
Using a dial indicator with a roller instrument, check the diaphragm spring tip alignment.
![]() |
If the alignment is not as specified, using SST, adjust the diaphragm spring tip alignment.
| 7. INSTALL MANUAL TRANSAXLE ASSEMBLY (for Manual Transaxle) |
| 8. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY (for Automatic Transaxle) |
| 9. INSPECT FOR OIL LEAK |