Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM (for Hatchback with VSC)

DTC    B1610/13    Front Airbag Sensor RH Malfunction


DESCRIPTION

The front airbag sensor RH circuit consists of the airbag sensor assembly and front airbag sensor RH.
The front airbag sensor RH detects impacts to the vehicle and sends signals to the airbag sensor assembly to determine if the airbag should be deployed.
DTC B1610/13 is stored when a malfunction is detected in the front airbag sensor RH.

DTC No.
DTC Detection Condition
Trouble Area
B1610/13
  1. Front airbag sensor RH malfunction
  2. Airbag sensor assembly malfunction
  1. Front airbag sensor RH
  2. Airbag sensor assembly

WIRING DIAGRAM


C234055E09


INSPECTION PROCEDURE

1.CHECK FRONT AIRBAG SENSOR RH


    C148689E24
  1. Turn the ignition switch off.

  1. Disconnect the cable from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

  1. Interchange the front airbag sensor RH with LH and connect the connectors.

  1. Connect the cable to the negative (-) battery terminal.

  1. Turn the ignition switch ON, and wait for at least 60 seconds.

  1. Clear the DTCs stored in memory (Click here).

  1. Turn the ignition switch off.

  1. Turn the ignition switch ON, and wait for at least 60 seconds.

  1. Check for DTCs (Click here).
    Result 
    Result
    Proceed to
    DTCs B1610/13 and B1615/14 are not output.
    A
    DTC B1610/13 is output.
    B
    DTC B1615/14 is output.
    C
    Text in Illustration 
    *1
    Front Airbag Sensor LH
    *2
    Airbag Sensor Assembly

    HINT:
    Codes other than DTCs B1610/13 and B1615/14 may be output at this time, but they are not related to this check.

  1. Turn the ignition switch off.

  1. Disconnect the cable from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

  1. Return the front airbag sensor RH and the front airbag sensor LH to their original positions and connect the connectors to them.



B
REPLACE AIRBAG SENSOR ASSEMBLY (Click here)

C
REPLACE FRONT AIRBAG SENSOR RH (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)