Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM (for Hatchback with VSC)

DTC    B1615/14    Front Airbag Sensor LH Malfunction


DESCRIPTION

The front airbag sensor LH circuit consists of the airbag sensor assembly and front airbag sensor LH.
The front airbag sensor LH detects impacts to the vehicle and sends signals to the airbag sensor assembly to determine if the airbag should be deployed.
DTC B1615/14 is stored when a malfunction is detected in the front airbag sensor LH.

DTC No.
DTC Detection Condition
Trouble Area
B1615/14
  1. Front airbag sensor LH malfunction
  2. Airbag sensor assembly malfunction
  1. Front airbag sensor LH
  2. Airbag sensor assembly

WIRING DIAGRAM


C234055E10


INSPECTION PROCEDURE

1.CHECK FRONT AIRBAG SENSOR LH


    C148689E25
  1. Turn the ignition switch off.

  1. Disconnect the cable from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

  1. Interchange the front airbag sensor LH with RH and connect the connectors.

  1. Connect the cable to the negative (-) battery terminal.

  1. Turn the ignition switch to ON, and wait for at least 60 seconds.

  1. Clear the DTCs stored in memory (Click here).

  1. Turn the ignition switch off.

  1. Turn the ignition switch to ON, and wait for at least 60 seconds.

  1. Check for DTCs (Click here).
    Result 
    Result
    Proceed to
    DTCs B1610/13 and B1615/14 are not output.
    A
    DTC B1615/14 is output.
    B
    DTC B1610/13 is output.
    C
    Text in Illustration 
    *1
    Front Airbag Sensor RH
    *2
    Airbag Sensor Assembly

    HINT:
    Codes other than DTCs B1610/13 and B1615/14 may be output at this time, but they are not related to this check.

  1. Turn the ignition switch off.

  1. Disconnect the cable from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

  1. Return the front airbag sensor LH and the front airbag sensor RH to their original positions and connect the connectors to them.



B
REPLACE AIRBAG SENSOR ASSEMBLY (Click here)

C
REPLACE FRONT AIRBAG SENSOR LH (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)