Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM (for Hatchback)

DTC    C1428    Motor Circuit Malfunction


DESCRIPTION


DTC No.
DTC Detection Condition
Trouble Area
C1428
With the ABS motor relay OFF and the ABS motor fail safe relay ON, an open in the motor circuit continues for 2 seconds or more.
Brake actuator assembly (Motor circuit)

WIRING DIAGRAM

Refer to DTCs C146C and C146D .

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK HARNESS AND CONNECTOR (GND2 TERMINAL)


    C231272E38
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A71-13 (GND2) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Skid control ECU)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (GND CIRCUIT)
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)