Home › Vehicle Exterior › DOOR / HATCH › FUEL LID LOCK CONTROL CABLE ASSEMBLY (for Sedan)

FUEL LID LOCK CONTROL CABLE ASSEMBLY (for Sedan) > REMOVAL



1. REMOVE FRONT SEAT ASSEMBLY
(Click here)


2. REMOVE REAR SEAT ASSEMBLY LH
(Click here)


3. REMOVE SPARE WHEEL COVER ASSEMBLY


    B136270
  1. Remove the spare wheel cover assembly.



4. REMOVE LUGGAGE COMPARTMENT TRIM INNER PAD


    B136275
  1. Remove the luggage compartment trim inner pad.



5. REMOVE DECK FLOOR BOX LH

HINT:
Use the same procedure as for the RH side .



6. REMOVE REAR FLOOR FINISH PLATE


    B349025
  1. Remove the 2 clips.

  1. Disengage the 8 claws and remove the rear floor finish plate.



7. REMOVE LUGGAGE COMPARTMENT TRIM INNER COVER LH

HINT:
Use the same procedure as for the RH side .



8. REMOVE FRONT DOOR SCUFF PLATE LH

HINT:
Use the same procedure as for the RH side .



9. REMOVE COWL SIDE TRIM BOARD LH

HINT:
Use the same procedure as for the RH side .



10. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH

HINT:
Use the same procedure as for the RH side .



11. REMOVE REAR DOOR SCUFF PLATE LH

HINT:
Use the same procedure as for the RH side .



12. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH

HINT:
Use the same procedure as for the RH side .



13. REMOVE LAP BELT OUTER ANCHOR COVER


    B134891
  1. Disengage the 3 claws and remove the lap belt outer anchor cover.



14. REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH


    B134892
  1. Remove the bolt and the anchor plate.



    B114296
  1. Remove the bolt and the shoulder anchor.



  1. Disconnect the pretensioner connector.



      B134893E01
    1. Using a screwdriver, release the locking button.

    2. Using a screwdriver, disconnect the pretensioner connector.



    B134896
  1. Remove the 2 bolts, the 2 hooks and the retractor.



15. REMOVE CENTER PILLAR LOWER GARNISH LH

HINT:
Use the same procedure as for the RH side .



16. REMOVE REAR SEAT SIDE COVER LH

HINT:
Use the same procedure as for the RH side .



17. REMOVE FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY


    B346795
  1. Remove the screw.

  1. Disengage the guide and disconnect the fuel lid lock open lever sub-assembly as shown in the illustration.



    B346796E01
  1. Disengage the 2 guides, disconnect the fuel lid lock control cable sub-assembly and luggage door lock control cable sub-assembly and remove the fuel lid lock open lever sub-assembly.

    Text in Illustration 
    *1
    Luggage Door Lock Control Cable Sub-assembly
    *2
    Fuel Lid Lock Control Cable Sub-assembly



18. REMOVE FUEL LID LOCK CONTROL CABLE SUB-ASSEMBLY


  1. Disengage the fuel lid lock control cable sub-assembly from the 5 clamps as shown in the illustration.


    B179141E01


    Text in Illustration 
    *1
    Fuel Lid Lock Control Cable Sub-assembly
    -
    -
    *a
    Clamp
    -
    -



    B179150
  1. Remove the fuel lid lock control cable sub-assembly by turning it counterclockwise and pulling it, as shown in the illustration.