DTC C1553 PIG Power Supply Overvoltage |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1553 |
|
|

| 1.CHECK HARNESS AND CONNECTOR (IG) |
![]() |
Disconnect the power steering ECU assembly connectors.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D104-1 (IG) - A68-2 (PGND) | Ignition switch ON | 11 to 14 V |
| *a | Rear view of wire harness connector (to Power Steering ECU Assembly) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (POWER STEERING ECU ASSEMBLY - BODY GROUND) |
![]() |
Disconnect the power steering ECU assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A68-1 (PIG) - Body ground | Ignition switch ON | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A68-2 (PGND) - Body ground | Always | Below 1 Ω |
| *a | Rear view of wire harness connector (to Power Steering ECU Assembly) |
|
| ||||
| OK | ||
| ||