Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW REGULATOR MOTOR (for Hatchback Front Door)

POWER WINDOW REGULATOR MOTOR (for Hatchback Front Door) > INSTALLATION



1. INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY
  1. Apply MP grease to the sliding and rotating areas of the regulator motor.

  1. Using "TORX" socket wrench T25, install the power window regulator motor with the 3 screws.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



2. INSTALL FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY
(Click here)