Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › AIR FUEL RATIO SENSOR (for Hatchback)

AIR FUEL RATIO SENSOR (for Hatchback) > INSTALLATION

for Preparation Click here



1. INSTALL AIR FUEL RATIO SENSOR


    A251200E01
  1. Using SST, install the air fuel ratio sensor.

    SST
    09224-00010  
    Text in Illustration 
    *a
    Fulcrum Length 300mm
    *b
    Fulcrum Length 30mm

    Torque:
    without SST:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }
    with SST:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }

    NOTICE:
    If a component has been dropped or subjected to a strong impact, replace it.

    HINT:
    1. The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
    2. The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.) (Click here).
    3. This torque value is effective when SST is parallel to the torque wrench.
    4. Perform "Inspection After Repairs" after replacing the air fuel ratio sensor (Click here).

  1. Connect the air fuel ratio sensor.

  1. Install the wire harness to the wire harness bracket.



2. INSTALL OUTER COWL TOP PANEL
  1. Install the outer cowl top panel with the 8 bolts.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }

  1. Engage the 2 clamps and install the wire harness.



3. INSTALL INNER COWL TOP TO COWL BRACE
  1. Install the cowl top to cowl brace with the 2 bolts.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }



4. INSTALL FRONT AIR SHUTTER SEAL RH
  1. Engage the clip and install the front No. 1 ventilator seal.



5. INSTALL FRONT NO. 1 VENTILATOR SEAL
  1. Engage the clip and install the front No. 1 ventilator seal.



6. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
(Click here)


7. INSPECT FOR EXHAUST GAS LEAK

HINT:
Perform "Inspection After Repairs" after repairing or replacing the exhaust system (Click here).