AIR FUEL RATIO SENSOR (for Hatchback) > REMOVAL |
| 1. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY |
| 2. REMOVE FRONT NO. 1 VENTILATOR SEAL |
![]() |
Disengage the clamp and remove the front No. 1 ventilator seal.
| 3. REMOVE FRONT AIR SHUTTER SEAL RH |
| 4. REMOVE INNER COWL TOP TO COWL BRACE |
![]() |
Remove the 2 bolts and the inner cowl top to cowl brace.
| 5. REMOVE OUTER COWL TOP PANEL |
![]() |
Disengage the 2 clamps and separate the wire harness.
Remove the 8 bolts and the outer cowl top panel.

| 6. REMOVE AIR FUEL RATIO SENSOR |
![]() |
Disconnect the air fuel ratio sensor connector.
Disengage the clamp and disconnect the air fuel ratio sensor wire from the wire harness clamp bracket.
![]() |
Using SST, remove the air fuel ratio sensor.