Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM (for Hatchback)

DTC    P0503    Vehicle Speed Sensor Circuit Malfunction


DESCRIPTION

If a malfunction (a rapid change in vehicle speed) in the vehicle speed signal being output from the skid control ECU*1,*2 or speedometer sensor*3 is detected while cruise control is in operation, the ECM determines there to be a momentary interruption or noise and stores a DTC.

DTC Code
DTC Detection Condition
Trouble Area
P0503
A malfunction in the vehicle speed signal is detected while cruise control is in operation.
  1. Anti-lock brake system*1
  2. Vehicle stability control system*2
  3. Vehicle speed sensor signal circuit
  4. Speedometer sensor*3
  5. Combination meter assembly
  6. ECM
  1. *1: w/ ABS
  2. *2: w/ VSC
  3. *3: w/o ABS

INSPECTION PROCEDURE

1.SYSTEM CHECK
  1. Check the vehicle specifications.
    Result 
    Result
    Proceed to
    w/ ABS (w/o VSC)
    A
    w/ VSC
    B
    w/o ABS
    C



B
Go to step 3

C
Go to step 4
A


2.CHECK FOR DTC (ANTI-LOCK BRAKE SYSTEM)
  1. Check for DTCs (Click here).

    OK:
    DTCs are not output.

    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
Go to step 4
A

GO TO ANTI-LOCK BRAKE SYSTEM (Click here)  

3.CHECK FOR DTC (VEHICLE STABILITY CONTROL SYSTEM)
  1. Check for DTCs (Click here).

    OK:
    DTCs are not output.

    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
GO TO VEHICLE STABILITY CONTROL SYSTEM (Click here)
A


4.CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Perform the following to make sure the DTC detection conditions are met.

    HINT:
    If the detection conditions are not met, the system cannot detect the malfunction.

    1. Drive the vehicle at a speed of approximately 40 km/h (25 mph) or more.

    2. Turn the cruise control main switch on.

    3. Push the cruise control main switch to -SET to activate cruise control.

  1. Check for DTCs (Click here).

    OK:
    DTC P0503 is not output.



NG
GO TO SFI SYSTEM (Click here)
OK

USE SIMULATION METHOD TO CHECK (Click here)