DTC P0571 Stop Light Switch Circuit Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| P0571 | The voltages of terminals ST1- and STP of the ECM are both below 1 V for 0.5 seconds or more. |
|

| 1.CHECK HARNESS AND CONNECTOR (STOP LIGHT SWITCH ASSEMBLY - BATTERY) |
![]() |
Disconnect the A65 switch connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A65-2 - Body ground | Always | 11 to 14 V |
| A65-4 - Body ground | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V |
| *a | Front view of wire harness connector (to Stop Light Switch Assembly) |
|
| ||||
| OK | |
| 2.INSPECT STOP LIGHT SWITCH ASSEMBLY |
Inspect the stop light switch assembly (Click here).
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (STOP LIGHT SWITCH ASSEMBLY - ECM) |
Disconnect the A65 switch connector.
Disconnect the A72 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A65-3 - A72-10 (ST1-) | Always | Below 1 Ω |
| A65-1 - A72-9 (STP) | ||
| A65-3 - Body ground | Always | 10 kΩ or higher |
| A65-1 - Body ground |
|
| ||||
| OK | ||
| ||