FRONT SEAT SIDE AIRBAG ASSEMBLY (for Hatchback Driver Side) > INSTALLATION |
| 1. INSTALL FRONT SEAT SIDE AIRBAG ASSEMBLY |
Install the front seat side airbag assembly with 2 new nuts.
Engage the 2 clamps.
Engage the 3 clamps to install the front seat side airbag wire harness.
| 2. INSTALL SEATBACK COVER WITH PAD (for TMC Made) |
![]() |
Install the seatback cover with pad to the separate type front setback spring assembly.
Install the front seatback cover bracket with the 2 new nuts. (w/ Front Seat Side Airbag)
![]() |
Fasten the 2 zippers. (for Sport Package)
![]() |
Align the protruding portion of the front seat headrest support with the installation groove of the separate type front seatback spring assembly.
| *a | Protruding |
Engage the 4 claws to install the 2 front seat headrest supports.
![]() |
Using hog ring pliers, install 3 new hog rings.
| *1 | Hog Ring |
| *a | Hog Ring Pliers |
![]() |
Using hog ring pliers, install 3 new hog rings.
| *1 | Hog Ring |
| *a | Hog Ring Pliers |
| 3. INSTALL SEATBACK COVER WITH PAD (for TMMF Made) |
![]() |
Install the seatback cover with pad to the separate type front setback spring assembly.
Install the front seatback cover bracket with the 2 new nuts. (w/ Front Seat Side Airbag)
![]() |
Align the protruding portion of the front seat headrest support with the installation groove of the separate type front seatback spring assembly.
| *a | Protruding |
Engage the 4 claws to install the 2 front seat headrest supports.
![]() |
Engage the 2 hooks.
![]() |
Engage the 3 hook.
| 4. INSTALL FRONT SEAT CUSHION INNER SHIELD |
![]() |
Engage the 2 claws to install the front seat cushion inner shield.
| 5. INSTALL FRONT SEAT CUSHION SHIELD |
![]() |
Engage the clip and 2 claws to install the front seat cushion shield.
Install the screw.
| 6. INSTALL VERTICAL ADJUSTING HANDLE (w/ Vertical Adjuster) |
![]() |
Install the vertical adjusting handle with the screw.
| 7. INSTALL RECLINING ADJUSTER RELEASE HANDLE |
![]() |
Install the vertical adjusting handle with the screw.
| 8. INSTALL FRONT SEAT HEADREST ASSEMBLY |
Install the front seat headrest assembly.
| 9. INSTALL FRONT SEAT INNER BELT ASSEMBLY |
| 10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 11. INSPECT SRS WARNING LIGHT |