Home › Vehicle Interior › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY (for Hatchback Driver Side)

FRONT SEAT INNER BELT ASSEMBLY (for Hatchback Driver Side) > INSTALLATION


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here). (w/ Front Seat Side Airbag)

NOTICE:
Always use E10 "TORX" socket wrench when removing the front seat assembly.



1. INSTALL FRONT SEAT INNER BELT ASSEMBLY


  1. for 4 Way Seat Type:



      B288269E02
    1. Install the front seat inner belt assembly with the nut.
      Text in Illustration 
      *a
      Convex

      Torque:
      42 N*m{ 428 kgf*cm , 31 ft.*lbf }

      NOTICE:
      Do not place the front seat inner belt assembly over the convex areas of the separate type front seat cushion spring assembly.

    2. Engage the clamp.

    3. Engage the 3 clamps.



  1. for 6 Way Seat Type:



      B286794E01
    1. Install the front seat inner belt assembly with the nut.
      Text in Illustration 
      *a
      Convex

      Torque:
      42 N*m{ 428 kgf*cm , 31 ft.*lbf }

      NOTICE:
      Do not place the front seat inner belt assembly over the convex areas of the separate type front seat cushion spring assembly.

    2. Engage the 2 clamps.

    3. Engage the 4 clamps.



2. INSTALL FRONT SEAT CUSHION COVER
  1. Engage the 2 hooks to install the front seat cushion cover.

  1. Install the 2 clips.



3. INSTALL FRONT SEAT ASSEMBLY
(Click here)


4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Front Seat Side Airbag)

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



5. INSPECT SRS WARNING LIGHT (w/ Front Seat Side Airbag)
(Click here)