DTC B2795 Unmatched Key Code |
| DTC Code | DTC Detection Condition | Trouble Area | DTC Output Confirmation Operation |
| B2795 | A key with a different vehicle serial number is inserted into the ignition key cylinder (1 trip detection logic*). |
| Insert the key into the ignition key cylinder. |
| Vehicle Condition when Malfunction Detected | Fail-safe Operation When Malfunction Detected |
| Engine cannot be started | - |
| DTC Code | Data List and Active Test |
| B2795 | Different Serial Number |
| 1.CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 2.CHECK FOR DTC |
Insert and remove each registered key one at a time, and check for DTCs each time (Click here).
| Result | Proceed to |
| OK | A |
| NG (any key) | B |
| NG (all keys) | C |
|
| ||||
|
| ||||
| A | ||
| ||
| 3.CHECK IGNITION SWITCH (OPERATION) |
Check that the ignition switch can be turned to ON using the key for which the DTC was stored.
|
| ||||
| OK | |
| 4.REREGISTER MALFUNCTIONING KEY |
Clear the DTCs (Click here).
Reregister the key code with the transponder key ECU assembly (Click here).
|
| ||||
| OK | ||
| ||
| 5.REPLACE TRANSPONDER KEY ECU ASSEMBLY |
Replace the transponder key ECU assembly (Click here).
| NEXT | |
| 6.REGISTER KEY |
Register the key (Click here).
| NEXT | |
| 7.REGISTER ECU COMMUNICATION ID |
Register the ECU communication ID (Click here).
| NEXT | |
| 8.CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 9.CHECK FOR DTC |
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||