TIRE PRESSURE WARNING RESET SWITCH (for Hatchback) > INSPECTION |
| 1. INSPECT TIRE PRESSURE WARNING RESET SWITCH |
![]() |
Remove the tire pressure warning reset switch (Click here ).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - 2 | ON | Below 1 Ω |
| OFF | 10 kΩ or higher |
| *a | Component without harness connected (Tire Pressure Warning Reset Switch) |
| *b | ON |
| *c | OFF |