This DTC is stored when LIN communication between the certification ECU (smart key ECU assembly) and steering lock ECU (steering lock actuator assembly) stops for 10 seconds or more.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B2786 | No Response from Steering Lock ECU | No communication between steering lock ECU (steering lock actuator assembly) and certification ECU (smart key ECU assembly) for 10 seconds or more. | ·
Steering lock ECU (steering lock actuator assembly) ·
Certification ECU (smart key ECU assembly) ·
Wire harness or connector ·
STRG LOCK fuse |
Inspect the fuses for circuits related to this system before performing the following procedure.
If the certification ECU (smart key ECU assembly) is replaced, register the keys (refer to Service Bulletin).
If the steering lock ECU (steering lock actuator assembly) is replaced, register the ECU code (refer to Service Bulletin).
Clear the DTCs.
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DTC CHECK / CLEAR
Recheck for DTCs.
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DTC CHECK / CLEAR
When DTC B2786 and B2785 are output simultaneously, perform troubleshooting for DTC B2785 first.
| Result | Proceed to |
|---|---|
| Only B2786 is output | A |
| DTC B2786 and B2785 are output simultaneously | B |
A
B
Disconnect the F15 steering lock ECU (steering lock actuator assembly) connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F15-7 (B) - F15-1 (GND) | Always | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F15-1 (GND) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the F43 certification ECU (smart key ECU assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F43-5 (LIN) - F15-5 (LIN) | Always | Below 1 Ω |
| F43-5 (LIN) - Body ground | Always | 10 kΩ or higher |
| F15-5 (LIN) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the steering lock ECU (steering lock actuator assembly).
Click hereSteering>STEERING COLUMN>STEERING COLUMN ASSEMBLY>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DTC CHECK / CLEAR
Recheck for DTCs.
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DTC CHECK / CLEAR
DTC B2786 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG