Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System) › 2013.08–2017.10
RM30M0E _58 Vehicle Interior _017118 HEATING / AIR CONDITIONING _0086573 AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System) C

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)  B1497  Communication Malfunction (Bus Ic)  


DESCRIPTION

The air conditioning harness assembly connects the air conditioning amplifier assembly and the servo motors. The air conditioning amplifier assembly supplies power and sends operation instructions to each servo motor through the air conditioning harness assembly. Each servo motor sends damper position information to the air conditioning amplifier assembly.

DTC No. Detection Item DTC Detection Condition Trouble Area Memory
B1497 Communication Malfunction (Bus Ic) Error or open in communication line
·

Air conditioning harness assembly

·

Harness or connecter between air conditioning amplifier assembly and power source

·

Air mix damper servo sub-assembly

·

Mode damper servo sub-assembly

·

Recirculation damper servo sub-assembly

·

Air conditioning amplifier assembly

·

Air conditioning panel circuit


Memorized
(10 seconds or more)*1

*1: The air conditioning amplifier assembly stores this DTC if the malfunction has occurred for the period of time indicated in the brackets.


WIRING DIAGRAM

E279033E02
5.26,2.813 6.625,3.198 1.365,0.385 10 false Air Mix Damper Servo Sub-assembly 1.479,0.167 1.635,0.354 0.156,0.188 10 false 4 1.042,0.354 1.396,0.542 0.354,0.188 10 false LIN1 1.448,0.344 1.802,0.531 0.354,0.188 10 false F3 1.458,3.698 1.813,3.885 0.354,0.188 10 false F3 1.458,3.313 1.813,3.5 0.354,0.188 10 false z2 1.458,2.917 1.813,3.104 0.354,0.188 10 false z2 1.458,2.51 1.813,2.698 0.354,0.188 10 false z2 5.104,0.177 5.26,0.365 0.156,0.188 10 false 2 5.104,0.792 5.26,0.979 0.156,0.188 10 false 8 5.115,1.323 5.271,1.51 0.156,0.188 10 false 5 5.292,0.344 5.646,0.531 0.354,0.188 10 false LIN1 5.292,0.875 5.646,1.063 0.354,0.188 10 false IG+ 5.292,1.406 5.646,1.594 0.354,0.188 10 false GND 5.146,1.688 5.5,1.875 0.354,0.188 10 false F4 5.135,1.833 6.604,2.219 1.469,0.385 10 false Air Conditioning Control Assembly 2.052,0.875 3.51,1.417 1.458,0.542 10 false from Ignition or Starter Switch Assembly*1 or No. 1 Ignition Relay*2 3.906,1.01 4.802,1.208 0.896,0.198 10 false ECU-IG NO. 1 0.896,2.521 1.406,2.719 0.51,0.198 10 false B BUS 1.031,2.927 1.542,3.125 0.51,0.198 10 false BUS 0.885,3.323 1.396,3.521 0.51,0.198 10 false BUS G 1.219,3.698 1.438,3.896 0.219,0.198 10 false B 1.49,2.344 1.646,2.531 0.156,0.188 10 false 4 1.49,2.75 1.646,2.938 0.156,0.188 10 false 3 1.49,3.135 1.646,3.323 0.156,0.188 10 false 2 1.458,3.531 1.75,3.719 0.292,0.188 10 false 21 0.26,4.104 1.823,4.5 1.563,0.396 10 false Air Conditioning Amplifier Assembly 0.635,5.052 1.458,5.292 0.823,0.24 10 false from Battery 1.948,5.177 2.417,5.375 0.469,0.198 10 false DOME 2.635,6.594 4.188,6.969 1.552,0.375 10 false Air Conditioning Harness Assembly 0.625,7.396 2.448,7.583 1.823,0.188 10 false : LIN Communication Line 4.615,7 6.927,7.208 2.313,0.208 10 false *1: w/o Smart Entry and Start System 4.625,7.344 6.938,7.552 2.313,0.208 10 false *2: w/ Smart Entry and Start System 2.958,2.427 3.469,2.625 0.51,0.198 10 false B BUS 2.958,2.75 3.469,2.948 0.51,0.198 10 false BUS 2.958,3.208 3.469,3.406 0.51,0.198 10 false BUS G 5.26,4.229 6.615,4.615 1.354,0.385 10 false Recirculation Damper Servo Sub-assembly 5.26,5.635 6.542,6.021 1.281,0.385 10 false Mode Damper Servo Sub-assembly

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


HINT:

DTCs B1497 and B14B2 may be output simultaneously.


PROCEDURE

1.PERFORM ACTIVE TEST USING GTS
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Air Conditioner / Active Test.


e.

According to the display on the GTS, perform the Active Test.

Body Electrical > Air Conditioner > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Air Mix Servo Targ Pulse(D) Air mix damper servo sub-assembly pulse Min.: 128
Max.: 383
Operates between 183 and 257 pulses
Air Outlet Servo Pulse (D) Mode damper servo sub-assembly pulse Min.: 128
Max.: 383
Operates between 252 and 316 pulses
Air Inlet Damper Targ Pulse Recirculation damper servo sub-assembly pulse Min.: 128
Max.: 383
Operates between 255 and 270 pulses
Body Electrical > Air Conditioner > Active Test
Tester Display
Air Mix Servo Targ Pulse(D)
50004 121 24
Body Electrical > Air Conditioner > Active Test
Tester Display
Air Outlet Servo Pulse (D)
50004 121 26
Body Electrical > Air Conditioner > Active Test
Tester Display
Air Inlet Damper Targ Pulse
50004 121 27
OK:

Arm of the damper servo motor selected in the Active Test operates smoothly.



f.

According to the test result, proceed to the next step.


Result:
Result Proceed to
One of the damper servo motors is malfunctioning A
All of the damper servo motors are malfunctioning B



A

2.SYSTEM CHECK

B

4.REPLACE AIR CONDITIONING HARNESS ASSEMBLY
2.SYSTEM CHECK
a.

According to the test, proceed to the next step.

Result:
Result Proceed to
Only the air mix damper servo sub-assembly is malfunctioning A
Only the recirculation damper servo sub-assembly is malfunctioning B
Only the mode damper servo sub-assembly is malfunctioning C




A

3.REPLACE AIR MIX DAMPER SERVO SUB-ASSEMBLY

B

8.REPLACE RECIRCULATION DAMPER SERVO SUB-ASSEMBLY

C

9.REPLACE MODE DAMPER SERVO SUB-ASSEMBLY
3.REPLACE AIR MIX DAMPER SERVO SUB-ASSEMBLY
a.

Replace the air mix damper servo sub-assembly.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING UNIT>DISASSEMBLY

HINT:

Since the air mix damper servo sub-assembly cannot be inspected while it is removed from the vehicle, replace the air mix damper servo sub-assembly with a new or known good one and check that the condition returns to normal.



b.

Check for the DTC.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)>DTC CHECK / CLEAR

NOTICE:

If the battery is disconnected, the past DTCs will be cleared.


Body Electrical > Air Conditioner > Trouble Codes
50001 121
Result:
Result Proceed to
DTC B1497 is not output A
DTC B1497 is output B




A

END (AIR MIX DAMPER SERVO SUB-ASSEMBLY WAS DEFECTIVE)

B

4.REPLACE AIR CONDITIONING HARNESS ASSEMBLY
4.REPLACE AIR CONDITIONING HARNESS ASSEMBLY
a.

Replace the air conditioning harness assembly.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING UNIT>DISASSEMBLY

HINT:

Since the air conditioning harness assembly cannot be inspected while it is removed from the vehicle, replace the air conditioning harness assembly with a new or known good one and check that the condition returns to normal.



b.

Check for the DTC.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)>DTC CHECK / CLEAR

NOTICE:

If the battery is disconnected, the past DTCs will be cleared.


Body Electrical > Air Conditioner > Trouble Codes
50001 121
Result:
Result Proceed to
DTC B1497 is not output A
DTC B1497 is output B




A

END (AIR CONDITIONING HARNESS ASSEMBLY WAS DEFECTIVE)

B

5.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - POWER SOURCE)
5.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - POWER SOURCE)
a.
E281476C01
1.479,0.115 1.927,0.323 0.448,0.208 0.354,1.375 0.24,1.688 true 1.615,0.115 1.927,0.313 0.313,0.198 10 false F3 0.198,1.698 0.51,1.896 0.313,0.198 10 false B 0.125,0.115 0.438,0.313 0.313,0.198 10 false *a
*a Front view of wire harness connector (to Air Conditioning Amplifier Assembly)


Disconnect the air conditioning amplifier assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
F3-21 (B) - Body ground Always 11 to 14 V



Result:
Result Proceed to
OK A
NG B



A

6.CHECK FOR DTC B14B2

B

REPAIR OR REPLACE HARNESS OR CONNECTOR

6.CHECK FOR DTC B14B2
a.

Confirm whether of DTC B14B2 is output.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)>DTC CHECK / CLEAR

NOTICE:

If the battery is disconnected, the past DTCs will be cleared.


Body Electrical > Air Conditioner > Trouble Codes
50001 121

Result:
Result Proceed to
DTC B14B2 is not output A
DTC B14B2 is output B



A

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

B

7.CHECK WHETHER DTC B14B2 PROCEDURE HAS BEEN COMPLETED
7.CHECK WHETHER DTC B14B2 PROCEDURE HAS BEEN COMPLETED
a.

Check whether DTC B14B2 procedure has been completed.


Result:
Result Proceed to
DTC B14B2 check procedure has not been completed A
DTC B14B2 check procedure has been completed B



A

B

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

8.REPLACE RECIRCULATION DAMPER SERVO SUB-ASSEMBLY
a.

Replace the recirculation damper servo sub-assembly.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING UNIT>DISASSEMBLY

HINT:

Since the recirculation damper servo sub-assembly cannot be inspected while it is removed from the vehicle, replace the recirculation damper servo sub-assembly with a new or known good one and check that the condition returns to normal.



b.

Check for the DTC.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)>DTC CHECK / CLEAR

NOTICE:

If the battery is disconnected, the past DTCs will be cleared.


Body Electrical > Air Conditioner > Trouble Codes
50001 121
Result:
Result Proceed to
DTC B1497 is not output A
DTC B1497 is output B




A

END (RECIRCULATION DAMPER SERVO SUB-ASSEMBLY WAS DEFECTIVE)

B

4.REPLACE AIR CONDITIONING HARNESS ASSEMBLY
9.REPLACE MODE DAMPER SERVO SUB-ASSEMBLY
a.

Replace the mode damper servo sub-assembly.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING UNIT>DISASSEMBLY

HINT:

Since the mode damper servo sub-assembly cannot be inspected while it is removed from the vehicle, replace the mode damper servo sub-assembly with a new or known good one and check that the condition returns to normal.



b.

Check for the DTC.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)>DTC CHECK / CLEAR

NOTICE:

If the battery is disconnected, the past DTCs will be cleared.


Body Electrical > Air Conditioner > Trouble Codes
50001 121
Result:
Result Proceed to
DTC B1497 is not output A
DTC B1497 is output B




A

END (MODE DAMPER SERVO SUB-ASSEMBLY WAS DEFECTIVE)

B

4.REPLACE AIR CONDITIONING HARNESS ASSEMBLY